Mitsumi electronic NZ2GF-ETB ユーザーズマニュアル
57
CHAPTER 6 INSTALLATION AND WIRING
6
6.3 T
est
ing the
ing the
Module Before Wiring
6.3
Testing the Module Before Wiring
(1) Unit test
Perform a unit test to check the Ethernet adapter module for hardware failure.
1.
Turn off the power.
2.
Connect PORT1 and PORT2 of the Ethernet
adapter module with an Ethernet cable.
3.
Turn on the power.
4.
With the switch on the Ethernet adapter
module, repeat 3 cycles of STOP
RESET/
TEST
STOP, taking less than 1 second per
cycle. (The MODE LED flashes after the third
cycle.)
cycle.)
5.
Hold the switch on the Ethernet adapter module
in the RESET/TEST position for 1 second or
more.
more.
Ethernet cable
Switch
Repeat at intervals of less than 1s.
: Flashing
Switch
1s or longer