Adder Technology AVX4016IP ユーザーズマニュアル
Power in connection
The.AdderView.CATx.unit.is.
supplied.with.a.single.30W.power.
adapter.which.is.sufficient.to.supply.
any.configuration.of.the.unit..The.
AdderView.CATx.IP.unit.has.two.
power.input.sockets.to.allow.an.
auxiliary.(redundant).power.adapter.
to.be.connected..There.is.no.on/off.
switch.on.the.unit,.so.operation.
begins.as.soon.as.a.power.adapter.
is.connected.
Note: AdderView CATx units require a heavy duty power adapter at either or
both power input connectors. Use only the adapter supplied with the unit or
available under Adder part number: PSU-IEC-5V6A. Do not use the standard
10W adapters that are supplied with other Adder products, such as the X100.
supplied.with.a.single.30W.power.
adapter.which.is.sufficient.to.supply.
any.configuration.of.the.unit..The.
AdderView.CATx.IP.unit.has.two.
power.input.sockets.to.allow.an.
auxiliary.(redundant).power.adapter.
to.be.connected..There.is.no.on/off.
switch.on.the.unit,.so.operation.
begins.as.soon.as.a.power.adapter.
is.connected.
Note: AdderView CATx units require a heavy duty power adapter at either or
both power input connectors. Use only the adapter supplied with the unit or
available under Adder part number: PSU-IEC-5V6A. Do not use the standard
10W adapters that are supplied with other Adder products, such as the X100.
To connect the power supply
1. Attach.the.output.lead.from.the.power.adapter.to.the.
MAIN PWR IN
.socket.
on.the.rear.panel.of.the.AdderView.CATx.
2. Connect.the.IEC.connector.of.the.supplied.country-specific.power.lead.to.
the.socket.of.the.power.adapter.
3. Connect.the.power.lead.to.a.nearby.main.supply.socket.
4. Repeat.steps.1.to.3.for.the.auxiliary.power.adapter.(using.the.
4. Repeat.steps.1.to.3.for.the.auxiliary.power.adapter.(using.the.
AUX PWR IN
.
socket),.if.a.backup.supply.is.required.
Note: Both the AdderView CATx and its power supply generate heat when in
operation and will become warm to the touch. Do not enclose them or place
them locations where air cannot circulate to cool the equipment. Do not operate
the equipment in ambient temperatures exceeding 40 degrees Centigrade. Do
not place the products in contact with equipment whose surface temperature
exceeds 40 degrees Centigrade. Using two power supplies will ensure that each
power supply takes less load and run at a correspondingly cooler temperature.
operation and will become warm to the touch. Do not enclose them or place
them locations where air cannot circulate to cool the equipment. Do not operate
the equipment in ambient temperatures exceeding 40 degrees Centigrade. Do
not place the products in contact with equipment whose surface temperature
exceeds 40 degrees Centigrade. Using two power supplies will ensure that each
power supply takes less load and run at a correspondingly cooler temperature.
AdderView CATx
rear panel
output lead from
power adapter