NEC NWA-008869-001 ユーザーズマニュアル
CHAPTER 5 EXAMPLES OF SETUP ON NETWORKS
– 122 –
NWA-008869-001 Rev.1.0
atch5001.fm
Checking
Use the show ipv6 route command to check the settings.
Use the show ipv6 route command to check the settings.
Setting RIPng
Setting
The following explains an example of setting RIPng.
The following explains an example of setting RIPng.
To set RIPng, use the ipv6 rip command in interface mode in which an RIPng routing advertisement can
be sent.
Enter the settings necessary to send and receive RIPng advertisements and validate the settings.
be sent.
Enter the settings necessary to send and receive RIPng advertisements and validate the settings.
In this example, the settings are entered on LAN2 (Ethernet network).
MEMO:
You can omit the ipv6 rip send command and the ipv6 rip receive command.
Router (config) # show ipv6 route
IPv6 Routing Table
− 7 entry
Codes : C
− Connected, L − Local, S − Static, R − RIPng
Timers : Uptime/Age
C 3ffe : 100 : : 0/64 default_site [0/1]
: : , interface FastEthernet0.0, 0 : 00 : 57/0 : 00 :00
L 3ffe : 100 : : 0/128 default_site [0/1]
: : , interface FastEthernet0.0, 0 : 00 : 58/0 : 00 : 00
L 3ffe : 100 : : 2/128 default_site [0/1]
: : , interface FastEthernet0.0, 0 : 00 : 57/0 : 00 : 00
C 3ffe : 200 : : 0/64 default_site [0/1]
: : , interface Ethernet0.0, 0 : 00 : 40/0 : 00 : 00
L 3ffe : 200 : : 0/128 default_site [0/1]
: : , interface Ethernet0.0, 0 : 00 : 41/0 : 00 : 00
L 3ffe : 200 : : 1/128 default_site [0/1]
: : , interface Ethernet0.0, 0 : 00 : 40/0 : 00 : 00
S 3ffe : 300 : : 0/64 default_site [1/1]
3ffe : 200 : : 2, interface Ethernet0.0, 0 : 00 : 05/0 : 00 : 00
Router (config) #
Enter
Router (config) # interface Ethernet0.0
Router (config
− Ethernet0.0) # ipv6 rip send
Router (config
− Ethernet0.0) # ipv6 rip receive
Router (config
− Ethernet0.0) # ipv6 rip enable
Router (config
− Ethernet0.0) #
Enter
Enter
Enter
Enter
ROUTING SETUP EXAMPLES (IPv6)