SATO 10e ユーザーズマニュアル
SATO M10e Service Manual
PN: 9001113A
Page 8-1
8
ADJUSTMENT PROCEDURES
This section provides instructions for mechanical and electrical adjustments to the printer.
Adjustments may be required following extended printer use or as a result of replacement
component activity.
Adjustments may be required following extended printer use or as a result of replacement
component activity.
PRINT HEAD POSITION
When properly aligned, the printing portion of the print head should make contact with the label at
the peak of the platen roller. If the head is adjusted so that it makes contact in advance of the
roller or on its back side, print quality will suffer.
the peak of the platen roller. If the head is adjusted so that it makes contact in advance of the
roller or on its back side, print quality will suffer.
1 Switch off the printer and disconnect the power supply cord.
2 Open the top housing cover to expose ribbon cover (1, Figure 8-1).
3 Remove media and ribbon stock as applicable.
3 Remove media and ribbon stock as applicable.
Figure 8-1, Print Head Position Adjustment
NOTE: Ensure that the print head is properly aligned prior to position
adjustment. The Print Head Alignment procedure may be found in this
section of the manual.
adjustment. The Print Head Alignment procedure may be found in this
section of the manual.
2
3
1