Marantz PM-14S1 ユーザーズマニュアル
7
Playback
Settings
Tips
Appendix
ENGLISH
Connections
Preparation
NOTE
• Disconnect this unit’s power plug from the power outlet before connecting the speakers.
• Connect the speaker cables so they do not stick out of the speaker terminals. The protection
circuit may be activated if the wires touch the rear panel or if the + and – sides touch each
other (vpage 24 “Protection circuit”).
• Never touch the speaker terminals while the power cord is connected. Doing so could result
in electric shock.
• Use speakers with an impedance of 4 – 8 Ω/ohms.
Cables used for connections
Provide necessary cables according to the devices you want to connect.
Speaker cable
Audio cable
R
L
R
L
Remote connector cable
Connections
Connecting the speakers
Connecting the speakers cables
Carefully check the left (L) and right (R) channels and + (red) and – (white) polarities on the
speakers being connected to the unit, and be sure to connect the channels and polarities
correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the tip of
the speaker cable, then either twist the core wire tightly or
apply solder to it.
2
Turn the speaker terminal counterclockwise to loosen it.
3
Insert the speaker cable’s core wire to all the way into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
Spade lug connector
When using a banana plug
Tighten the speaker terminal firmly
before inserting the banana plug.
1.PM14S1U_ENG_0722.indd 7
2013/07/25 17:08:25