3M 10700 ユーザーズマニュアル
6
(Specifications continued on next page)
1.
Power Requirements:
Electrical: 115 VAC, 60 Hz, 5.6 A (680 watts)
Pneumatic: 5 bar gauge pressure [70 PSIG]
Pneumatic: 5 bar gauge pressure [70 PSIG]
110 liter/min @ 21° C, 1.01 bar [3.75 SCFM] at 15 boxes per minute
A pressure regulator is included
A pressure regulator is included
The machine is equipped with two 1/6 HP motors and comes with an 2.4 m [8 foot] standard neoprene covered
power cord and a grounded plug. Contact your 3M Representative for power requirements not listed above.
power cord and a grounded plug. Contact your 3M Representative for power requirements not listed above.
2.
Operating Rate:
Up to 15 boxes per minute. Actual production rate is dependent on box size, box size mix, and operator
dexterity.
dexterity.
Box drive belt speed is approximately 0.38 m/s [75 FPM]
3.
Operating Conditions:
Use in dry, relatively clean environments at 4°C to 50°C [40°F to 120°F] with clean, dry, boxes.
Note: Machine should not be washed or subjected to conditions causing moisture condensation on
components.
components.
Specifications
4.
Tape:
Scotch
®
pressure-sensitive film box sealing tapes.
5.
Tape Width:
36 mm or 1.5 inches minimum to 50 mm [2 inches] maximum
6.
Tape Roll Diameter:
Up to 405 mm [16 inches] maximum on a 76.2 mm [3 inches] diameter core.
(Accommodates all system roll lengths of Scotch
®
film tapes.)
7.
Tape Application Leg Length—Standard:
70 mm ± 6 mm [2.75 inches ± 0.25 inches]
Tape Application Leg Length—Optional:
(See "Special Setup Procedure")
50 mm ± 6 mm [2 inches ±1/4 inches]
(See "Special Setup Procedure")
50 mm ± 6 mm [2 inches ±1/4 inches]
•
To reduce the risk associated with fire and
explosion hazards:
−
Do not operate this equipment in potentially
flammable or explosive environments.
WARNING