Enterasys Networks 2G4072-52 ユーザーズマニュアル
Completing the Installation
3-18 Installation
Completing the Installation
After installing the Enterasys Matrix N SA 2G4072‐52 and making the connections to the
network, access the device management startup screen from your PC, terminal, or modem
connection as described in the following section.
network, access the device management startup screen from your PC, terminal, or modem
connection as described in the following section.
Log-In Using a Console Port Connection
Start the Command Line Interface (CLI) from the device’s local console port as follows:
1.
Connect a terminal to the local console port as described in “
”on page 3‐13. The startup screen,
, displays.
Modem Port Adapter Wiring and Signal Diagram
RJ45
DB25
Pin
Conductor
Pin
Signal
1
Blue
2
Transmit (TX)
2
Orange
8
Data Carrier Detect (DCD)
4
Red
3
Receive
5
Green
7
Ground (GRD)
6
Yellow
20
Data Terminal Ready (DTR)
8
Gray
22
Ring Indicator
RJ45 Connector (Female)
Pins
8
1
Pins
DB25 Connector (Male)
13
1
25
14
Note: This procedure applies only to initial log-in and to logging in to a device not yet
configured with administratively-supplied user and password settings.
configured with administratively-supplied user and password settings.
By default, the Matrix N Standalone Series device is configured with three user login
accounts: ro for Read-Only access; rw for Read-Write access; and admin for super-user
access to all modifiable parameters. The default password is set to blank (carriage return).
For information on changing these default passwords, refer to Chapter 3 in the
accounts: ro for Read-Only access; rw for Read-Write access; and admin for super-user
access to all modifiable parameters. The default password is set to blank (carriage return).
For information on changing these default passwords, refer to Chapter 3 in the
Enterasys
Matrix N Standalone Series Configuration Guide
.