Motorola P880 ユーザーズマニュアル

Cajun P880 Routing Switch Installation Guide 

2 - 35

To use TCP/IP applications (Telnet, HTTP, and SNMP) over your PPP 
serial port interface:

1. From My Computer, double-click Dial-Up Networking. The 

Dial-Up Networking program group opens.

2. Double-click on the PPP modem previously created. The 

Connect To dialog box opens.

3. Enter your password and click Connect. A Pre-Dial Terminal 

Screen opens.

When the modem has successfully connected, a Post-Dial 
Terminal Screen opens.

4. In the Post-Dial Terminal screen, login using your CLI user 

name and password. It may be necessary to enter several 
carriage returns to view the Login prompt.

5. At the CLI prompt, go to configuration mode and enter set 

console transfer PPP. ASCII characters display below the CLI 
prompt. This is typical while the switch attempts to connect via 
PPP.

6. In the Post-Dial Terminal screen, click Continue (F7). PPP 

verification completes and the Connected To dialog box displays 
a message that the modem connection has been successfully 
established.

To configure the PPP console with an IP address and mask:

1. Configure your console serial port as a PPP Console. See 

2. Connect your modem cable to the Cajun’s serial port.

3. From the IP Configuration section of the Web Agent, click 

Interfaces. The IP Interfaces dialog box opens.

4. Click CREATE. The Add IP Interface dialog box opens.

5. From the VLAN pull-down menu, select Serial-Console. This 

specifies the interface for the PPP console.

6. In the Network Address field, enter the IP address to be 

associated with the PPP console port.

* Note:  If you do not enter a name for this interface, the 

IP address is used as the interface name.