Fujitsu N800 ユーザーズマニュアル
U41243-J-Z156-1-76
11
2
Important notes
2.1
Notes on safety
In this section you will find information that you must note when using the
storage subsystem.
storage subsystem.
This device complies with the relevant safety standards for IT equipment,
including electronic office machines, intended for use in the office environment.
including electronic office machines, intended for use in the office environment.
I
Observe the safety instructions in the “Safety, Warranty and Ergonomics”
manual and in the documentation for the connected PRIMERGY system.
manual and in the documentation for the connected PRIMERGY system.
If you have any questions relating to setting up and operating your system in the
environment where you intend to use it, please consult our service organization.
environment where you intend to use it, please consult our service organization.
V
CAUTION!
●
The actions described in these instructions should only be performed
by technicians, service personnel or technical specialists. Equipment
repairs should only be performed by qualified staff. Any failure to
observe the guidelines in this manual could expose the user to
considerable risks (electric shock, fire hazards) and could also
damage the equipment. Note that any unauthorized opening of the
device will result in the invalidation of the warranty and exclusion from
all liability.
by technicians, service personnel or technical specialists. Equipment
repairs should only be performed by qualified staff. Any failure to
observe the guidelines in this manual could expose the user to
considerable risks (electric shock, fire hazards) and could also
damage the equipment. Note that any unauthorized opening of the
device will result in the invalidation of the warranty and exclusion from
all liability.
●
Transport the device in its original packaging or in other suitable
packaging which will protect it against shock or impact.
packaging which will protect it against shock or impact.
●
Read the notes on environmental conditions in section “Technical
data” on page 9 before setting up and operating the device.
data” on page 9 before setting up and operating the device.
●
If the device is brought in from a cold environment, condensation may
form both inside and on the outside of the machine.
form both inside and on the outside of the machine.
Wait until the device has acclimatized to room temperature and is
absolutely dry before starting it up. Material damage may be caused
to the device if this requirement is not observed.
absolutely dry before starting it up. Material damage may be caused
to the device if this requirement is not observed.
●
Check that the rated voltage specified on the device's ID plate is the
same as the local line voltage.
same as the local line voltage.