Perle Systems SCS8C DC ユーザーズマニュアル

ページ / 460
Hardware and Connectivity  46
Powering up your IOLAN
z
IOLAN I/O models with Analog I/O for setting Voltage/Current.
See 
 to see how to set the jumpers for your IOLAN desktop model.
Medical Unit Models
To power up the medical unit IOLAN, perform the following steps:
1.
You can attach the multi-function wall plate included with your medical unit IOLAN to the wall, 
then mount the IOLAN on the wall plate. Alternatively, you can mount the IOLAN on a tabletop 
or any suitable horizontal surface. See the IOLAN MDC Hardware Installation Guide for more 
information on how to mount the medical unit IOLAN.
2.
Plug a power cable into the left side (power/Ethernet panel) of the IOLAN unit and then into the 
electrical outlet. 
3.
Power on the IOLAN unit using the Power ON/OFF switch.
4.
You will see the LEDs blink for several seconds and then remain a solid green, indicating that it 
is ready to configure/use. 
Terminal Block Models
Perform the following steps to power up the unit:
1.
Ensure power is NOT applied to the wires prior to connection.
2.
On each end wire, remove the insulation from the copper wire 5 mm (3/16 of an inch). 
3.
Loosen the left screw on the top of the terminal connector block, then insert your positive (+) 
wire into the left terminal and screw it down tight. Loosen the right screw on the top of the 
terminal connector block, then insert your negative (-) wire into the right terminal and screw it 
down tight.
4.
Plug the power supply into the electrical outlet.
5.
A solid green LED indicates the unit is powered up. 
For I/O models, you should set the IOLAN jumpers for Digital I/O (see 
Analog Input (
) channels.
Note:
For I/O models the Terminal Block is plugable.
Left
Right
+
-