Motion Computing AB52242 ユーザーズマニュアル

10

Chapter 

1  Getting Started with Your Tablet Client

Your Motion Tablet Client is equipped with a smart battery that provides 
information about its power status.

CAUTION: To avoid personal injury, or the risk of fire 

or explosion if the battery is overheated, wait until the 

battery cools to room temperature before recharging 

or replacing it.

NOTE: If the unit is operating on battery power, you 

can move the pen over the Power/Battery icon 

(shown here and found in the system tray at the 

lower-right corner of the Tablet Client display) to see 

the number of hours of battery life and the percentage of 

battery charge remaining.

Refer to “Power Management” on page 27 for more information about your 
battery and power settings. 

Power

Battery

Hard 
Disk
Drive

Wireless

Steady blue

Battery charged
(AC plugged in)

None

Amber

Battery charging (AC plugged 
in)

None

NOTE: When the remaining battery charge is 10%, your Tablet Client issues a Low 
Battery alarm message in addition to the LED warning. For information about 
modifying this alarm (you can set it to display a message or to produce an audible 
warning), refer to “Configuring Your Power Management Settings” on page 27.

Fast-flashing amber 
(lasts only a few 
seconds)

3% battery charge remaining
(AC unplugged)

The Tablet Client issues a 
Critical Battery alarm and 
automatically goes into 
Stand By mode. 

Slow-flashing amber The battery is too hot to charge Move the Tablet Client/ 

battery to a cooler 
environment until the 
temperature is closer to 
normal.

Off

Tablet Client is unplugged from 
AC power and the system is 
running on battery power.

Plug the Tablet Client into 
AC power if you want to 
preserve battery power.