GE GFK0579B ユーザーズマニュアル
1
19
Chapter 1 Introduction
Configurable Features
The following table summarizes configuration options for a remote drop, and
compares them to the PLC configuration required with a remote drop. The remote
drop can be configured, or reconfigured, using Logicmaster 90–70 or a Genius
Hand–held Monitor, or datagrams. If the configuration is not protected, as explained
on the next page, a reconfiguration will replace part or all of an existing configuration,
regardless of the configuration method originally used.
compares them to the PLC configuration required with a remote drop. The remote
drop can be configured, or reconfigured, using Logicmaster 90–70 or a Genius
Hand–held Monitor, or datagrams. If the configuration is not protected, as explained
on the next page, a reconfiguration will replace part or all of an existing configuration,
regardless of the configuration method originally used.
Remote Drop Configuration
Configuration Item
Logicmaster
90–70
Hand–held
Monitor
Datagrams
Device Number (SBA)
n[
n
Series 90–70 References
n[
n
Write Map
Data Lengths
n[
n
Write Map
Series Six/Series Five References
•
n
Baud Rate
n[
n
Bus Controller Options:
Input Default
n
Outputs Enabled
n
I/O Module Options:
Input Filter Time
n
Outputs Default
n
Voltage/Current Range
n
Analog Expander Modules
n
PCM*, GDS*, ADS*
n
Genius Options:
BSM Controller *
n
n
BSM Present *
n
n
Timeout Select *
n
n
CPU Redundancy *
n
n
Duplex Default *
n
n
Configuration Protection
]
n
SNP Port Options:
SNP ID Write Map
n
Baud Rate
n
Stop Bits
n
Modem TT
n
Idle Time
n
Remote I/O Scanner Sweep Control:
Programmer Window
n
n
Communications Window
n
n
[ with release 3 software, PLC configuration must match the remote drop configuration.
•
Only for a new Remote I/O Scanner, for which no Series Six/Series Five reference has been entered.
* Not approved for use with Remote I/O Scanner version IC697BEM733A;
upgrade to IC697BEM733B or later.
upgrade to IC697BEM733B or later.
] Automatically supplied.