Multi-Tech Systems FF130 ユーザーズマニュアル
Chapter 2: Getting Started
14
FaxFinder Administrator User Guide
Rack Mounting
When installing the unit in a closed or multi-unit enclosure, follow the recommended installation
defined by the enclosure manufacturer.
defined by the enclosure manufacturer.
Note:
The ambient temperature of the rack interior must not exceed 60° Celsius.
●
Do not place the unit directly on top of other equipment or place other equipment directly on top of
the unit.
the unit.
●
If installing the unit in a closed or multi-unit enclosure, ensure adequate airflow within the rack so
that the maximum recommended ambient temperature (60° C) is not exceeded.
that the maximum recommended ambient temperature (60° C) is not exceeded.
●
Ensure that the unit is properly connected to earth ground by verifying that it is reliably grounded
when mounted within a rack.
when mounted within a rack.
●
If a power strip is used, ensure that the power strip provides adequate grounding of the attached
apparatus.
apparatus.
●
When mounting the equipment in the rack, make sure mechanical loading is even to avoid a
hazardous condition. The rack should safely support the combined weight of all the equipment it
supports.
hazardous condition. The rack should safely support the combined weight of all the equipment it
supports.
●
Ensure that the mains supply circuit is capable of handling the load of the equipment. See the power
label on the equipment for load requirements.
label on the equipment for load requirements.
●
This equipment should only be installed by properly qualified service personnel. Only connect like
circuits - connect SELV (Secondary Extra Low Voltage) circuits to SELV circuits and TN
(Telecommunications Network) circuits to TN circuits.
circuits - connect SELV (Secondary Extra Low Voltage) circuits to SELV circuits and TN
(Telecommunications Network) circuits to TN circuits.
19-Inch Rack Enclosure Mounting Procedure
Attaching the FaxFinder to the rail of an EIA 19-inch rack enclosure will likely require two people. Attach
the brackets to the FaxFinder chassis with the screws provided, as shown in the figure above, and then
secure unit to rack rails by the brackets. Because equipment racks vary, screws for rack-rail mounting
are not provided. Follow the instructions of the rack manufacturer and use screws that fit.
the brackets to the FaxFinder chassis with the screws provided, as shown in the figure above, and then
secure unit to rack rails by the brackets. Because equipment racks vary, screws for rack-rail mounting
are not provided. Follow the instructions of the rack manufacturer and use screws that fit.
1.
Position the right rack-mounting bracket on the FaxFinder using the two vertical mounting screw
holes.
holes.
2.
Secure the bracket to the FaxFinder using the two screws provided.
3.
Position the left rack-mounting bracket on the FaxFinder using the two vertical mounting screw
holes.
holes.
4.
Secure the bracket to the FaxFinder using the two screws provided.