Multiquip b46s90 ユーザーズマニュアル

Before the trowel can be put into operation there are some 

components that must be installed before the trowel can 

be used. This section provides general instructions on how 

to install those components.  Instruction sheet P/N 20485 

provides further details for the handle assembly.

13.  Attach the main handle (tube) to the gearbox as shown 

in (Figure 4). The mounting hardware should be 

contained in the shipping container.

1.  The vibratory T-handle bar is already attached to the 

main handle tube.

2.  To adjust the height of the T-bar, loosen the star wheel 

(Figure 5) and position T-handle bar in the desired 

position.

3.  Tighten star wheel firmly.

GEARBOX

3/8 FLAT

WASHER

3/8-16 X 3.25

HHC SCREW

MAIN HANDLE

(TUBE)

3/8-16

NYLOC NUT

T-HANDLE BAR

HEIGHT

ADJUSTMENT

STAR WHEEL

1.  Uncoil the throttle cable and housing.
2.  Feed the throttle cable through the cable housing. 
3.  Connect the

 trowel throttle cable to the engine 

throttle linkage (Figure 6). There should be a piece of 

wire installed on the trowel to show where to route the 

throttle cable. 

4.  Route 

cable end through the cable locking screw. 

When connecting the 

cable housing, make sure that 

no more than 1/4" (6.4 mm) of the 

cable housing 

protrudes past the 

housing clamp on the engine.

5.  Tighten 

cable clamp screw.

6.  After the trowel throttle cable has been connected to  

the engine throttle linkage, adjust and tighten operator 

position of the T-bar handle to lock the throttle cable at 

the proper length. 

If additional handle height adjustment is desired, a 

handle wedge kit can be purchased for your trowel by 

ordering P/N 2576 from your Multiquip dealer. 
These wedges are placed between the handle and the 

gearbox to adjust the operating height of the handle. 

This kit comes complete with wedges, new bolts and 

installation instructions. This will move your operating 

handle position up or down approximately 3” (76 mm).

THROTTLE

CABLE

ENGINE

THROTTLE

LEVER

1/4”

(6.35 MM)

CABLE HOUSING

CLAMP/SCREW

CABLE

LOCKING

SCREW