Honeywell N431X ユーザーズマニュアル

3 - 15

This allows you to set the length (in seconds) for power save timeout.  To set the 
length scan the Power Save Timeout bar code below, then set the timeout 
(from 0-65535 seconds) by scanning digits from the 

, then 

.  The scan engine goes into a power save mode (Sleep or Hiber-

nate) at timeout after a successful scan or the duration of inactivity.  

Default = 

600 seconds.

The scan engine has three Power Save Modes: Off, Sleep Mode, and Hiber-
nate.  In Off mode, all components are powered on and the scan engine is in 
operating mode.  In Sleep Mode, the laser, motor, and micro are powered off.  
In Hibernate, all components are powered off.  The scan engine enters Power 
Save Mode after the timeout occurs.  See 

3-15 for further information.  

Default = Off.

To control engine’s aimer before and after scanning or to control the aimer with 
an external aiming pin, scan one of the bar codes below. 

 Default = Aimer 

Always Off.