Makita DPC6411 ユーザーズマニュアル

Press the cutting attachment (13) onto the drive arm in the

side position.
Guide the V-belt (14) over the V-belt pulley (15).
NOTE: The illustration shows the V-belt for models DPC6410

- 7321).

Put the guard plate (16) on.
Screw on nuts (17) and tighten by hand.
To tighten the V-belt see ”Tightening the V-belt / Checking V-

belt tension”.
Screw in and tighten the screw (detail X, only for DPC8112).
Tighten the nuts (17) firmly with the combination wrench.
Replace the grip (18) as shown.

IMPORTANT:

When you reposition the cutting attachment, the direction

of rotation of the cutting wheel changes.

If a rotation direction is marked on the cutting disc, make

sure the disc turns in the right direction.

Replacing/cleaning the spark arrester screen

The spark arrester screen should be checked and cleaned

regularly.

Models without catalytic converter
Loosen the 2 screws (19) and remove the spark arrester

screen (20).

Models with catalytic converter
Unscrew and remove screws (21). Remove the front housing

section of the muffler (22).
Unscrew and remove screw (23). Remove the deflector plate

and spark arrester screen (24).

CAUTION:

Do not use sharp or pointed objects for screen cleaning.

Damaged or misformed screen wires may result.
Reassembly the spark arrester screen and tighten the screws.
Information on the catalytic converter: The catalytic converter

reduces the pollutant content of the exhaust.

Models without catalytic converter

Models with catalytic converter