Multiquip SFCS-16 ユーザーズマニュアル

 

 

 

 

BLADES ARE EXTREMELY SHARP. CONTACT 
WITH THE BLADE CAN RESULT IN PROPERTY 
DAMAGE AND/OR PERSONAL INJURY. BLADES 
ARE PROVIDED WITH A PROTECTIVE COVER 
OVER THE CUTTING EDGE. EXERCISE EXTREME 
CAUTION WHEN REMOVING AND/OR 
REINSTALLING THE PROTECTIVE COVER. STORE 
THE BLADE WITH THE PROTECTIVE COVER 
PROPERLY INSTALLED TO MINIMIZE THE 
POTENTIAL FOR BLADE DAMAGE AND/OR 
PERSONAL INJURY. 
 
7) Return the FLOOR COVERING SCRAPER to its 
normal operating position. 
 
8) Determine that the ON/OFF switch located on the 
operator handle is in the OFF position.  IF the FLOOR 
COVERING SCRAPER is to be used immediately, 
then reconnect the extension cord or FLOOR 
COVERING SCRAPER to the power source. 
 

 

 

 

 
OPERATIONAL DISCLAIMER. 
 
THE MANUFACTURER OF THE FLOOR COVERING 
SCRAPER MAKES NO WARRANTY OR 
GUARANTEE THAT IT IS MERCHANTABLE 
AND/OR SUITABLE FOR ANY SPECIFIC JOB 
APPLICATION AND THAT IT WILL HAVE THE 
CAPABILITY AND POWER REQUIRED TO 
REMOVE ANY SPECIFIC COVERING FROM ANY 
SPECIFIC WORK SURFACE. 
 
CALIFORNIA PROPOSITION 65 DISCLAIMER. 
 
 

 

 

CAUSE CANCER, BIRTH DEFECTS, OR OTHER 
REPRODUCTIVE HARM. 
 
INFORMATION RELATIVE TO MINIMUM 
COMPONENT STANDARDS FOR THE OPERATION 
OF THE FLOOR COVERING SCRAPER. 
For operational safety  and overall productivity 
considerations, it is required that specific FLOOR 
COVERING SCRAPER components meet minimum 
acceptable operational standards BEFORE utilization: 
1) Operator handle be properly mounted to the main 
frame, with factory supplied ball-detent type retaining 
pins that properly secure the handle to the main frame 
while in the work position. 
 
2) The operator handle is equipped with properly fitting 
handle grips of sufficient integrity to allow for proper 
job function as outlined within this manual. Loose 
fitting handle grips or grips without full end caps  are 
not permitted. 
 
3) An ON/OFF motor switch that allows it to perform its 
intended job function as outlined within this manual. 
Replace  any damaged ON/OFF motor switch with a 
factory approved replacement part only. 
 
4) An extension cord and GFI that  allows this 
accessory to perform its intended job function as 
outlined within this manual. Replace  any damaged 
extension cord or GFI with a  factory  approved 
replacement part only. 
 
5) Exciter plate elastomeric rubber mounts which allow 
them to perform their intended job function as outlined 
within this manual.  Do not operate the FLOOR 
COVERING SCRAPER without the correct number of 
exciter plate elastomeric rubber mounts. Do not 
operate the FLOOR COVERING SCRAPER with a 
damaged  and/or improperly secured rubber mount. 
Replace  any damaged rubber mount with a  factory 
approved replacement part only. 
 
6) Blade(s)  and/or ceramic tile ripper attachment of 
proper structural integrity (void of cracks, etc), 
straightness, sharpness, etc which are retained by the 
proper fasteners. Replace  worn  or  damaged blades, 
fasteners and the ceramic tile ripper attachment with a 
factory approved replacement part only. 
 
7) All safety decals, Operator Manual and operational 
information decals (including the applicable Quik Tips 
information) must be in proper and readable condition. 
Replace  any missing or damaged safety decal, 
Operator Manual  and/or information decal with a 
factory approved replacement part only.