Multiquip MP2090HP ユーザーズマニュアル

The MP2 Masonry Saw gasoline model utilizes some of the
same procedures that are used for the electric models.
Please reference pages 20 and 21 for the below referenced
procedures:
■ Conveyor Cart Placement

■ Blade Selection and Inspection

■ Saw Blades

■ Blade Installation
Assembly (Gasoline Powered Saws Only)

1.

Remove the saw from its container and place it on a
stable, level surface. Make sure location you choose
can support the weight of the saw. The saw location
should be rigid and stationary so that the saw will not
move, sag, or sway due to the vibrations and
movements of the saw.

2.

The 

gasoline powered saw uses a mechanical water

pump. This pump operates by drawing power from the
drive V-belts, and has been adjusted 

operation when shipped from the factory.

3.

Fill the water tray with clean fresh water.  The 

pump intake (strainer) must always be fully covered
by water to operate effectively.  Also, keep the pump
intake free of sludge, debris and other materials that
may accumulate in the tray.

4.

Make certain that the water hose will not come in
contact with the blade or interfere with any moving
parts.  The best location for the water pump/strainer is
between the splash shield and the rear of the water
tray.  This will prevent some of the abrasive particles
from flowing through the pump.

The mechanical water pump is
shipped from the factory for 

cutting applications.

To connect the

 mechanical water pump to the drive V-

belts for 

Wet Cutting, perform the following:

1.

Loosen the 2 hex head cap screws (Figure 12) that
secure the pump mount bracket.

2.

Push the pump handle downward to engage the pump.
The drive belt should have approximately 1/8 to 3/16
inch belt deflection.

3.

Tighten the 2 hex head cap screws that secure the
pump mount bracket.

 NOTE

4.

With the engine running, squeeze the water pump
priming bulb (Figure 13) until water begins to flow
through the water lines. If the pump is working correctly,
the cutting blade should be covered with a steady water
mist. This will keep the blade cool while cutting.

ALWAYS position the strainer in the water tray in a manner
that will allow the free movement of the conveyor cart, and
clearance from the cutting blade and cutting action.

Whenever cleaning, adjusting or lubricating any part
of the saw, MAKE CERTAIN to stop the engine and
disconnect the spark plug wire from the spark plug.