Jonsered CC 2145 ユーザーズマニュアル

22 – 

English

Start throttle: (FC 2145, FC 2145 S, FC 2145 W, BC 2145, 
CC 2145)

Set the throttle to the start position by moving the choke 
control to the choke position and then returning it to its original 
position.

If the machine is fitted with a decompression valve (A): Press 
the valve to reduce the pressure in the cylinder and make 
starting easier. You should always use the decompression 
valve when starting the machine. Once the machine has 
started the valve will automatically return to its original 
setting.

Hold the body of the machine on the ground using your left 
hand (CAUTION! Not with your foot!). Grip the starter handle, 
slowly pull out the cord with your right hand until you feel 
some resistance (the starter pawls grip), now quickly and 
powerfully pull the cord. Never wrap the starter cord around 
your hand

Repeat pulling the cord until the engine starts. When the 
engine starts. return choke control to run position and apply 
full throttle; the throttle will automatically disengage from the 
start setting.

CAUTION!  Do not pull the starter cord all the way out and do 
not let go of the starter handle when the cord is fully extended. 
This can damage the machine.

Stop the engine by switching off the ignition.

Models equipped with heating elements in the handles have 
an on/off switch on the throttle handle to control the heat. Both 
the left and right handles have heating elements that 
automatically maintain a temperature of roughly 70

° when the 

heat is turned on.