Multiquip MTX80SD ユーザーズマニュアル

page 14 — MTX80SD RaMMeR • opeRaTion anD paRTS Manual — Rev. #0 (07/20/12)

inspeCtiOn

It is extremely important that this section be read carefully

before attempting to operate the rammer.

Do noT use

your rammer until this section is thoroughly understood.

CRankCaSe anD SpRing CylinDeR oil BaTH

This unit uses an oil bath lubrication system. Perform the

following:
1. Check the oil level through the oil level sight glass

(Figure 3) at the rear of the tamper foot.

Figure 3. Foot Housing Sight Glass

2. If oil is not visible, add 10W-30 SE, SF or higher grade

motor oil into the oil fill plug opening (Figure 3). The

bath contains approximately 1.7 pints (800 cc.)

engine

1. Fill the fuel tank (Figure 4) with unleaded gasoline. At

the same time, check the engine oil and make it a habit

to replenish it often (Figure 5).

Figure 4. Fuel Tank

SIGHT GLASS

OIL DRAIN PLUG

OIL FILL PLUG

NOTICE

The oil level should be kept at the half way point of the

sight glass.

FUEL

TANK

Figure 5. Engine Oil Dipstick

2. Low levels of oil may result in engine seizure due to

high levels of consumption during operation.

3. Check the engine oil level and if the engine oil level is

low, it should be refilled. Use the proper motor oil as

suggested in the Table 3 below.

geneRal inSpeCTion

1. Check all nuts, bolts fasteners for tightness. Retighten

as necessary.

2. Clean any dirt from the recoil starter and foot pedestal.

Wipe the entire unit clean before operating.

3. Replace any missing or damaged Safety Operation

decals.

4. Adjust height of handle. Adjust handle by loosening

nuts and moving handle to suit operation. Retighten

nuts.

OIL LEVEL

DIPSTICK

Table 3. Motor oil grade

Season or Temperature

Grade of motor oil

(higher than MS class)

Spring, Summer or Autumn

+120° F to +15° F

SAE 30

Winter

+40° F to +15° F

SAE 30

Below +15° F

SAE 10W-30