Jenn-Air W10418362B ユーザーズマニュアル

Using 2 or more people, stand dishwasher. upright.
NOTE: Do not install kick plate until instructed to do so.

IMPORTANT: Double-check correct placement of utilities. Grasp 
the sides of the dishwasher at the edges of the door panel. Tilt 
dishwasher backward on wheels and move dishwasher close to 
cabinet opening.
NOTE: Do not push on the front of the panel or on the console. 
Panel or console may dent.
Helpful Tip: Temporarily tape utilities to the floor in the locations 
shown to prohibit them from moving when dishwasher is moved 
into the cabinet opening.

Check that water line is on the left side of opening and drain hose 
is near the center of the cabinet opening.

With another person holding the dishwasher to keep it from 
tipping, open and close the door a few times. If the door closes or 
falls open under its own weight, the door tension will need to be 
adjusted.

To adjust the door spring tension, unhook the spring from the rear 
leg of dishwasher.
Using a 

⁵⁄₁₆" nut driver or hex socket, remove the screw from the 

tensioner.
The screw can be put into one of three holes (1, 2, 3) in the front 
leg of dishwasher. If the door closes by itself, move the tensioner 
to a higher number hole and replace the screw. Reattach door 
spring to rear leg. 
NOTE: Tensioners on both sides of dishwasher should be secured 
at same holes.