Jenn-Air W10418362B ユーザーズマニュアル

ページ / 48
22
Check that top of door does not contact screws, brackets or 
countertop. If it does, adjust leveling legs.
Open door and check that space between dishwasher cabinet 
opening and tub is equal on both sides. If spacing is not equal, 
loosen bracket screws secured and shift tub. Tighten bracket 
screws.
If securing with a side attachment, check that sides of door do not 
rub against the screw heads. If they do, dishwasher must be 
re-centered. When dishwasher is properly centered, replace 
plastic buttons.
Remove towel from dishwasher. Reinstall the lower dish rack.
If needed, see website for animated representation of this step. 
Visit www.jenn-air.com/anchoring under FAQ tab.
Bottom Sound Pad Installation
(on some models)
1. Remove the bottom sound pad from inside the dishwasher 
and take it out of the plastic bag.
2. Place pad on the floor in front of the dishwasher, making sure 
lettering is facing up and vinyl pad faces down.
3. Fold up and hold the side panels down. Slowly slide the pad 
toward the back of the dishwasher as far as it will go, making 
sure not to push or pull any wires or hoses. (Do not force.) 
Side panels will open to proper position.
NOTE: If there are pipes or other obstructions coming up 
through the floor, you will need to cut a slit in the pad to fit 
around the obstacle.
4. Fold the front end of the pad up into position. Make sure the 
vinyl pad is tucked up behind the door and the dishwasher 
front legs, as shown.