Jackson M24STD-6 ユーザーズマニュアル
M24STD-6 INSTALLATION INSTRUCTIONS
2
Installation Instructions 07610-003-26-13
Issued: 08-10-2006 Revised: N/A
Tools Required:
•
Standard Allen wrench set
•
Tube of food-grade silicon
•
Silicon gun
•
Rag
Time Requirements:
It is expected that it will take 30 minutes to
It is expected that it will take 30 minutes to
install the M24STD-6 dishmachine stand.
Notes:
•
Ensure that the dishmachine stand is
level prior to placing the dishmachine
on the stand.
level prior to placing the dishmachine
on the stand.
•
Never attempt to lift a dishwasher on
your own. Always use other personnel
to help or the appropriate lifting devices
to prevent accident and injury.
your own. Always use other personnel
to help or the appropriate lifting devices
to prevent accident and injury.
Steps:
•
Inspect the assembly to ensure that
there has been no freight damage. If
there is any damage, contact the
freight carrier immediately.
there has been no freight damage. If
there is any damage, contact the
freight carrier immediately.
•
Your package should contain the fol-
lowing:
lowing:
•
Stand platform weldment
•
(4) legs
•
Instructions
•
If any of these items are missing, im-
mediately contact Jackson Technical
Service at 1-888-800-5672.
mediately contact Jackson Technical
Service at 1-888-800-5672.
•
Remove the items from the box.
•
Ensure that the set screws are located
within the leg sockets. If they are miss-
ing, immediately contact Jackson
Technical Service (See Figure 1).
within the leg sockets. If they are miss-
ing, immediately contact Jackson
Technical Service (See Figure 1).
•
Verify that the foot of each leg can be
turned; this is how the stand will be ad-
justed in order to level it. Please note
that when assembled, there should be
a minimum of 6” (152.4mm) of space
between the bottom of the stand and
the finished floor.
turned; this is how the stand will be ad-
justed in order to level it. Please note
that when assembled, there should be
a minimum of 6” (152.4mm) of space
between the bottom of the stand and
the finished floor.
•
Place the legs fully into the leg sockets
of the platform and tighten down the
set screws to secure them in place.
(See Figure 2).
of the platform and tighten down the
set screws to secure them in place.
(See Figure 2).
•
Once all of the legs are tightly in place,
flip the dishmachine stand over and set
it down on all four legs. Ensure that the
legs are stable.
it down on all four legs. Ensure that the
legs are stable.
•
If stable, take a small amount of silicon
and apply it to the set screw to cover
any exposed threads and to fill in the
hole for the Allen wrench. (See Figure
3). Note: do not use excessive
amounts of silicon; only enough to
complete the task.
and apply it to the set screw to cover
any exposed threads and to fill in the
hole for the Allen wrench. (See Figure
3). Note: do not use excessive
amounts of silicon; only enough to
complete the task.
Figure 1—Leg socket showing set screw
Figure 2—Tightening the legs