Jackson 200 ユーザーズマニュアル
37
200 Series Technical Manual
7610-100-45-00 Rev. E (02/10/2006)
SECTION 6: PARTS SECTION
MOTOR ASSEMBLY
The 200 models covered in this manual come supplied with various wash motor assemblies (a wash motor assembly includes
the wash motor and the pump end), depending on the characteristics of the machine. To ensure that you order the correct wash
motor assembly for the model you are servicing, please refer to the following table:
the wash motor and the pump end), depending on the characteristics of the machine. To ensure that you order the correct wash
motor assembly for the model you are servicing, please refer to the following table:
Model
Volts
Hz
Phase
Wash Motor Assembly
200/200B/200LT/200S
208
60
1
06105-102-05-94
200/200B/200LT/200S
230
60
1
06105-102-05-94
200/200B/200LT/200S
208
60
3
06105-102-04-94
200/200B/200LT/200S
230
60
3
06105-102-04-94
200/200B/200LT/200S
460
60
3
06105-102-04-94
Important note: When servicing a wash motor, it is important to refer to the wiring schematic found on the motor, to ensure
that the motor is wired correctly. Different manufacturers of motors may not use the same wire color codes and therefore, your
new motor, which may have been built by someone different than who built your original motor, may not connect using the same
wires. Always refer to the wiring diagrams on the motor you are installing. If the motor you are installing has had the schemat-
ic removed, contact Jackson MSC immediately for technical support.
that the motor is wired correctly. Different manufacturers of motors may not use the same wire color codes and therefore, your
new motor, which may have been built by someone different than who built your original motor, may not connect using the same
wires. Always refer to the wiring diagrams on the motor you are installing. If the motor you are installing has had the schemat-
ic removed, contact Jackson MSC immediately for technical support.
ITEM
DESCRIPTION
Mfg. No.
1
Motor, 208/230/460V, 1 HP, 1 Phase
06105-102-08-94
1
Motor, 208/230/460V, 1 HP, 3 Phase
06105-102-01-94
2
Adapter Plate
04730-801-00-00
3
O-Ring, Adapter Plate
05330-400-18-00
4
Mechanical Seal
05330-300-07-27
5
Impeller
04320-300-44-00
6
Pump Casing
04320-300-45-00
7
"Square Ring" Seal
05330-500-23-00
8
Flange, Suction Pipe
04320-300-43-00
9
Slinger Washer
N/A
10
Washer (3 phase only)
N/A
11
Screw, 1/4”-28 x 1/2” (3 pahse only)
N/A
10
11