Frigidaire FFGC3015LW ユーザーズマニュアル

9

Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is COOL. REMOVE 

SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANING WILL REDUCE THE NUMBER OF 

MAjOR CLEANING LATER.

Use hot, soapy water and a cloth. Dry with a clean cloth. 

Using a soft cloth, clean with mild dish detergent and water or a 50/50 solution of 

vinegar and water. Follow by rinsing the area with clean water; dry and polish with a 

soft cloth. Glass cleaners may be used if sprayed on a soft cloth first. do not spray 

liquids directly on the control pad and display area. Do not use large amounts of 

water on the control panel - excess water on the control area may cause damage to 

the appliance. Do not use other liquid cleaners, abrasive cleaners, scouring  pads, or 

some paper towels - they will damage the finish.

Wipe the control panel clean after each use. Before cleaning the control panel, turn 

all controls to OFF and remove the control knobs. To remove, pull each knob straight 

off the shaft. Clean using hot, soapy water and a cloth. Be sure to squeeze excess 

water from the cloth before wiping the panel; especially when wiping around the 

controls. Excess water in or around the controls may cause damage to the appliance. 

To replace knobs after cleaning, line up the flat sides of both the knob and the shaft; 

then push the knob into place.

Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water 

and a cloth. do not use cleaners with high concentrations of chlorides or 

chlorine. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are 

especially made for cleaning stainless steel. Always be sure to rinse the cleaners 

from the surface as bluish stains may occur during heating that cannot be removed.

Burner Grates, Burner Rings 

(some models), Cooktop 

Surface

Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 

1:1 solution of clear water and ammonia. If necessary, cover difficult spots with 

an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and 

a damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry 

with a clean cloth or paper towel. Remove all cleaners or the porcelain may become 

damaged during future heating. do not use spray oven cleaners on the cooktop.

The holes in the burners of your cooktop must be kept clean at all times for proper 

ignition and a complete, even flame. Clean the burner holes routinely with a small 

gauge wire or needle and especially after bad spillovers which could clog these 

holes.
To remove and replace burner units per your model, see instructions under general 

cleaning. To clean, soak the burners in a 1:1 solution of ammonia and water for 

30 to 40 minutes. For stubborn stains, scrub with soap and water or a mild abrasive 

cleanser and damp cloth. Dry the burners thoroughly in a warm oven for 30 minutes. 

Then replace them, making sure they are seated and level. do not wash burner 

units in the dishwasher.