Dacor DYWS4 ユーザーズマニュアル

Installation Instructions

Installation

•  To avoid personal injury, use only the included gas 

pressure regulator or a Dacor specified replacement.

•  Do not use any power supply other than the one 

provided with the system or a Dacor approved 

replacement. Do not attempt to modify or bypass the 

power supply.

1.  Before installation, make sure any access holes for 

the power cord and gas tubing have been drilled in 

adjoining cabinets as necessary to allow them to 

pass through to the electrical outlet and gas cylinder 

location.

2.  Plug one end of the plastic gas tubing (provided) 

into the inert gas connector at the back of the wine 

dispensing system.

3.  If required route the plastic gas tubing though any 

access holes drilled in the adjoining cabinets.

4.  Plug the power cord (provided) into the power plug on 

the power supply (black rectangular box) mounted on 

the back of the wine dispensing system. 

5.  If required, route the power cord though any access 

holes drilled in the adjoining cabinets.

6.  Make sure the cable coming from the power supply 

(opposite the power cord that connects to the wall) is 

connected to the 

Power Input connector on the back 

of the unit. Also, check to make sure that both of the 

micro-switches located on the back of the unit are in 

the up position.

7.  Slowly and gently lift the unit up and back into the final 

location. As you do this, have someone gently pull the 

gas tubing and power cable through the access holes 

into the adjacent cabinets (if necessary). Exercise care 

to make sure that the wiring and tubing lines do not 

become damaged. Make sure the require 1” (2.5 cm) 

space is maintained above and below the unit.

  continued...

Connect power 

supply output 

here

Connect to  

120 Vac 60 Hz. 

electrical outlet

120 Vac 

power cord

Power 

supply

These connectors 

used by qualified 

service personnel only

Inert gas

connector

Plastic gas

tubing