Mitsubishi Electronics A0567659 ユーザーズマニュアル

Gravimetric Batch Blenders w/Mitsubishi Control       Chapter 8:  Addendum 

94 

This screen allows you to modify the type of each feeder.  In most cases, the user will want to 
keep regrind on hopper 3 because that blender has been specifically designed to handle the 
regrind.  These settings should only be modified under special circumstances.    

If the blender is configured in “Quickset Mode” then one hopper must be configured for 
Regrind and only one hopper must be configured for Virgin material.  If this is incorrect, a 
message will be given on the Recipe Screen. 

 

 

This screen allows the user to change the blender’s unit of measurement.  The entire blender 
can be configured in either Kgs. or Lbs., while the Target vs. Actual data can be configured 
for either regardless of the blender’s units. 

 
 
 
 
 
 
 
 
 

 

This screen allows the blender to be configured for use with the Ethernet Option.  The 
blender will automatically configure the Ethernet module’s IP Address and Subnet Mask if 
the configurator is enabled.  Whenever you modify the IP Address or subnet, you either need 
to reboot the PLC or touch “Send Ethernet Config to Module.” 

 

 

Go back to  

Engineering Only 

Directory. 

Change Target vs. 
Actual Units 

Change 
Blender’s 
Units 

Go back to 
Setup 
Directory 

Enable or 
Disable the 
Ethernet 
Module 
Configurator 

Change 
Blender’s IP 
Address and 
Subnet Mask 

Go back to 
Setup 
Directory