Multiquip CX400HFE ユーザーズマニュアル
CX-HF SERIES MIXERS — OPERATION AND PARTS MANUAL — REV. #3 (03/11/08) — PAGE 13
CX-HF SERIES HAND MIXERS — SETUP
Assembly
Before using the hand mixer, the following steps need to be
performed.
Before using the hand mixer, the following steps need to be
performed.
1.
Insert the mixing tools (see Table 3 for the different
mixing tools/paddles available) into the HEXAFIX
mixing tools/paddles available) into the HEXAFIX
®
coupling as far as necessary to lock the tools in place,
automatically (see Figure 2).
automatically (see Figure 2).
Electric Connections
1.
Connect the hand mixer power cable to a 110V or
230V, 50/60 Hz power source, depending on the unit
you have. Make sure you conform to the specifications
on the nameplate of the mixer.
230V, 50/60 Hz power source, depending on the unit
you have. Make sure you conform to the specifications
on the nameplate of the mixer.
Figure 3. Extension Cord (Wet Hands)
To prevent personnel from tripping over
the extension cord, position the
extension cord so that it lays flat and is
not curled.
not curled.
NOTE
DO NOT attempt to operate the mixer until the Safety,
General Information and Set-Up sections have been read
and understood.
General Information and Set-Up sections have been read
and understood.
CAUTION
Figure 2. Inserting Mixing Tools
PULL BACK
INSERT
CAUTION
Before plugging the power cable, check and make sure
that the ON/OFF switch operates properly and returns to
the OFF position when released.
that the ON/OFF switch operates properly and returns to
the OFF position when released.
2.
A 120V/230V power supply can also be used. Make
sure that the power supply conforms to the
specifications on the nameplate of the mixer. Voltage
decrease of more than 10% will cause loss of power
and overheating.
sure that the power supply conforms to the
specifications on the nameplate of the mixer. Voltage
decrease of more than 10% will cause loss of power
and overheating.
3.
Use an extension cord (see Table 2) of adequate current
carrying capacity.
carrying capacity.
NEVER use a worn or frayed exten-
sion cord. Insert the electric motor's power plug into one
end of the extension cord.
end of the extension cord.
NEVER touch the power cord (Figure 3) with wet hands or
while
while
standing in water when it is connected to a power
source. The possibility exists of electrical shock
(electrocution) even death.
(electrocution) even death.
NEVER spray water directly
on the electric motor.
DANGER