Manitowoc Ice K00375 プリント

The K00375 kit is used for installing Q-1400 or Q-Dual ice machines on a C-730 bin. 

1.  Note:  Bin must be level before installation of ice machine. 

A.  Remove the foam tape from the front and sides of the bin where the stainless deflector will be located. 
B.  Remove RH and LH hinge screws and bin door.  Remove fillers and old deflector. 
C.  Place the deflector on the front edge of the bin and align with front bin edge. 
D.  Place the fillers on the bin, as shown.  Make sure the two holes from the stainless deflector and fillers are 

aligned on the side. 

E.  Apply foam tape to the front and back of the bin between the fillers.  Note:  All other required foam tape 

comes preassembled with the stainless deflector and fillers. 

F.  Note:  It is recommended to RTV intersections and along the inside edge of the foam tape to prevent water 

tracking. 

2.  Refer to ice machine installation manual for ice machine installation procedures. 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
Manitowoc Ice, Inc. 

2110 South 26

th

 Street, P.O. Box 1720, Manitowoc, WI  54221-1720 USA                                                                                                 000000262 

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879                                                Sheet 1 of 2 
Web Site - www.manitowocice.com                                                                                                                                                                    08/11/05 

Filler 

Filler 

Double layer of .75” 
Wide Foam Tape on 
Deflector between Fillers

INSTALLER: It is recommended to 
RTV intersections and along inside 
edge of Foam Tape to prevent water 
tracking 

Filler 

#10-24 x .50”L 

Screws Typ 

Stainless Steel 

Deflector 

.75” Wide Foam Tape
 

RH and LH Hinge 

Screws