Multiquip MVC-40G ユーザーズマニュアル

1. Place the engine 

fuel valve lever (Figure 11) in the "ON"

position.

4. Place the

 throttle  lever (Figure 14) in the slow position

(idle)

2. Place the

 engine ON/OFF switch (Figure 12) in the "ON "

position.

This section is intended to assist the operator with the 

start-up of the plate compactor.  It is extremely important that
this section be read carefully before attempting to use the
compactor in the field.

DO NOT attempt to operate the plate compactor
until the Safety, General Information and
Inspection sections of this manual have been
read and  thoroughly understood.

5. Grasp the starter grip (Figure 15) and slowly pull it out. The

resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.

3. Place the

 choke lever (Figure 13) in the "CLOSED " position

if starting a 

cold engine,  if starting a warm engine or the

temperature is warm, place the choke lever  in  the "OPEN"
position

6. Let the engine warm for a few minutes without a load and

check for  fuel leaks, and noises that would associate with a
lose component.