Multiquip MT-74FA ユーザーズマニュアル

1 . Check all nuts, bolts fasteners for tightness. Retighten as

necessary.

2. Clean  any dirt from the recoil  starter and  foot pedestal.   Wipe

the entire unit clean  before operating.

3. Replace any missing or damaged Safety Operation decals.

4. Adjust height of handle. Adjust handle by loosening nuts and

moving handle to suit operation. Retighten nuts.

When starting the MT-74FA Tamping Rammer perform  the
following:

1.

Open the  fuel shut-off valve by moving the 

fuel  cock  lever

to the 

open position (Figure 7) then set  the engine start/

stop switch  (Figure 6) to the "START" position.

3. Close the choke lever  (Figure 9)  and move the throttle lever

to the "Full Open" position. Turning the choke lever 90
degrees clockwise closes the choke . In cold weather, start the
unit with choke fully closed. In warm weather or when the
engine is warm, the unit can be started with choke halfway
or completely open.

2.

Set  the engine ON/OFF switch (Figure 8) to the "ON"
position (start).

4. Grip the recoil starter  (Figure10) handle and pull it until you

feel a slight resistance. Then pull sharply and quickly. Return
the recoil starter handle to the starter case before releasing.

5. If engine fails to start, move the choke lever (Figure 9)  to the

half open position to avoid flooding.

6. Repeat steps 1 thru 4.

7.

If the engine does not start after repeated attempts,
check the spark plug for excess fuel. Clean and replace
the spark plug as needed.