KitchenAid W10291426A ユーザーズマニュアル

ページ / 76
23
Install Classic Series Custom Panels
IMPORTANT: KitchenAid is not responsible for the removal or 
addition of molding or decorative panels that would not allow 
access to the refrigerator for service.
Door Panels
1. Remove all tape and door bracing from the refrigerator and 
freezer doors. 
2. Remove the screws that attach the handles to the door frame. 
3. Slide the decorative door panels into the door frames. 
4. If needed, route the door panels or install a filler panel 
between the doors and the decorative panels. See the 
“Classic Series Custom Panels” section in “Installation 
Requirements.”
5. Replace the door handles. Install the top screw on each 
handle first. Be sure that the top of both door handles are 
aligned.
6. If the door handles are not aligned, loosen all handle screws 
and adjust door handles up or down. Tighten the screws.
7. Check refrigerator level and adjustment. Adjust if needed.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up, then pull straight out. Place the top grille 
panel-side down on a soft working surface. 
3. Remove one end cap by loosening the nuts and sliding off the 
end cap. 
4. Slide the backer panel into the top grille channel and reattach 
the end cap. 
5. Replace the top grille in the cabinet side trims and pull the 
panel down slightly to lock it into place. 
Install Overlay Series Custom Panels
IMPORTANT: 
Install the custom handles prior to installing the panels on the 
refrigerator. For more information on KitchenAid custom 
handle selection, refer to the KitchenAid Catalog, visit 
www.kitchenaid.com, or call 1-800-442-9991. In Canada, 
visit www.KitchenAid.ca, or call 1-800-807-6777.
Create custom door overlay panels according to the 
specifications in the “Overlay Series Custom Panels” section.
KitchenAid is not responsible for the removal or addition of 
molding or decorative panels that would not allow access to 
the refrigerator for service.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator and 
freezer doors.
2. Open the refrigerator and freezer compartment doors.
A. Panels
A. Top grille
B. Cabinet side trim
A
A
B
B
A
A. Bottom rail
B. Nuts
C. End cap
D. Top rail
A. Backer panel
A. Top grille
B. Cabinet side trim
C
B
A
D
A
B
B
A