KitchenAid KSSC42FMS ユーザーズマニュアル

3. Remove the handle side and top trims. 

4. Slide the custom panels into the bottom and hinge side trims 

on the refrigerator compartment and freezer compartment 
doors, making sure that the backer panel fits into the hinge 
side trims.

5. Reinstall the handle-side and top trims.

6. Remove the protective skin from the screw covers. Slide or 

snap the screw covers into the handle trim section.

7. Check refrigerator level and alignment. Adjust if needed.

Use the following steps to adjust the door height, up or down, 
after the doors have been leveled.

1. Open the freezer or refrigerator door. Locate the bottom hinge 

and remove the door stop screw.

 Models

Remove the door stop screw from the bottom side of the 
hinge with a 

³⁄₈" open end wrench.    

Overlay Models 
Remove the two door stop screws: one from the bottom side 
using a 

³⁄₈" open end wrench and one from the top side using 

a 

⁵⁄₃₂" Allen wrench. 

2. Remove the locking plate as shown. 

3. Turn the bushing located underneath the bottom of the hinge 

using a 

¹⁄₂" open end wrench. Turning the bushing to the left 

(counterclockwise) will raise the door. Turning the bushing 
right (clockwise) will lower the door. 

A

A

A

A

A

B

C

A

B