KitchenAid W10608689A オーナーマニュアル

The Door Ajar Alarm feature sounds an alarm when the refrigerator 
or freezer door is open for 5 minutes and the product cooling is 
turned on. The alarm will repeat every 2 minutes. Close both 
doors to turn it off. The feature then resets and will reactivate 
when either door is left open again for 5 minutes.
NOTE: To mute the audible alarm while keeping the doors open, 
such as while cleaning the inside of the refrigerator, press any 
button on the control panel. The alarm sound will be temporarily 
turned off, but “DOOR AJAR” will still be displayed on the 
dispenser control panel. 

Convertible Drawer Temperature Control

(on some models)

The control can be adjusted to properly chill meats or vegetables. 
The air inside the pan is cooled to avoid “spot” freezing and can 
be set to keep meats at the National Livestock and Meat Board 
recommended storage temperatures of 28° to 32°F (-2° to 0°C). 
To store meat:

Set the control to one of the three MEAT settings to store meat at 
its optimal storage temperature.
To store vegetables: 

Set the control to VEG to store vegetables at their optimal storage 
temperatures. 
NOTE: If food starts to freeze, move the control to the right (less 
cold), toward the VEG setting. Remember to wait 24 hours 
between adjustments.

Crisper Humidity Control 

You can control the amount of humidity in the moisture-sealed 
crisper. Adjust the control to any setting between LOW and HIGH.
LOW (open) for best storage of fruits and vegetables with skins. 
HIGH (closed) for best storage of fresh, leafy vegetables. 

Water and Ice Dispensers

■

The dispensing system will not operate when the freezer door 
is open.

■

Allow 24 hours for the refrigerator to cool down and chill 
water.

■

Allow 24 hours to produce the first batch of ice. Discard the 
first three batches of ice produced. Wait 72 hours for full ice 
production.

■

The display screen on the dispenser control panel will turn off 
automatically and enter “sleep” mode when the control 
buttons and dispenser lever have not been used for 2 minutes 
or more. While in “sleep” mode, the first press of a control 
button will only reactivate the display screen, without 
changing any settings.

Air in the water dispensing system can cause the water dispenser 
to drip. After connecting the refrigerator to a water source or 
replacing the water filter, flush the water system. Flushing the 
water dispensing system forces air from the water line and filter, 
and prepares the water filter for use.
NOTE: As air is cleared from the system, water may spurt out of 
the dispenser.
1. Using a sturdy container, depress and hold the water 

dispenser lever for 5 seconds, then release it for 5 seconds. 

2. Repeat Step 1 until water begins to flow. 

3. Once water begins to flow, continue depressing and releasing 

the dispenser lever (5 seconds on, 5 seconds off) until a total 
of 3 gal. (12 L) has been dispensed. 

Additional flushing may be required in some households.

■

Dispense at least 1 qt (1 L) of water every week to maintain a 
fresh supply.

■

If the flow of water from the dispenser decreases, it could be 
caused by low water pressure.

■

With the water filter removed, dispense 1 cup (237 mL) of 
water. If 1 cup of water is dispensed in 8 seconds or less, 
the water pressure to the refrigerator meets the minimum 
requirement.

■

If it takes longer than 8 seconds to dispense 1 cup of 
water, the water pressure to the refrigerator is lower than 
recommended. See “Water Supply Requirements” or 
“Problem Solver” for suggestions.

1. Press ICE/WATER until “water” is selected, as shown on the 

display screen. 

2. Press a sturdy glass against the dispenser lever. Hold the 

glass close to the water dispenser spout to ensure that the 
water dispenses into the glass.    

3. Remove the glass to stop dispensing.
IMPORTANT: The small tray at the bottom of the dispenser is 
designed to catch small spills and allow for easy cleaning. There is 
no drain in the tray. To empty and clean the tray, push down on 
the back of the removable tray lid and pull it out. 

Ice dispenses from the ice maker storage bin in the freezer when 
the dispenser lever is pressed. To turn off the ice maker, see “Ice 
Maker and Storage Bin.”
Your ice maker can produce both crushed and cubed ice. Before 
dispensing ice, select which type of ice you prefer by pressing the 
ICE/WATER button. 
The display screen indicates which type of ice is selected.

A