Frigidaire 318205258 ユーザーズマニュアル

9

In the event of an electrical power outage, the surface 

burners can be lit manually. To light a surface burner, 

hold a lit match to the burner head, then slowly turn the 

surface control knob to LITE. After burner lights turn the 

knob to desired setting. Use caution when lighting surface 

burners manually.

Never extend the fl ame beyond the outer edge of the 

utensil. A higher fl ame simply wastes heat and energy, and 

increases the risk of being burned by the gas fl ame.

1.  Place cooking utensil on surface burner.

2. Push the surface control knob down and turn 

counterclockwise out of the OFF position.

For most cooking - start on the highest control setting and 

then turn to a lower one to complete the process. Use the 

recommendations below as a guide for determining proper 

fl ame size for various types of cooking. The size and type 

of utensil used and the amount of food being cooked will 

infl uence the setting needed.

top of the range when it is in use. These items could 

melt or ignite. Pot holders, towels or wood spoons could 

catch fi re if placed too close to a fl ame.

time without cookware on the grate. The fi nish on the 

grate may chip without cookware to absorb the heat.

High Flame

Start most foods; bring water to a boil; 

pan broiling.

Medium Flame Maintain a slow boil; thicken sauces, 

gravies; steaming.

Low Flame

Keep foods cooking; poach; stewing.

Í

using other types of pans. The color of the fl ame is 

the key to proper burner adjustment. A good fl ame  is 

clear, blue and hardly visible in a well-lighted room. Each 

cone of fl ame should be steady and sharp. Clean burner 

if fl ame is yellow-orange.

3.  Release the knob and rotate to the LITE position. Note: 

All fi ve electronic surface ignitors will spark at the same 

time. However, only the burner you are turning on will 

ignite.

4.  Visually check that the burner has a fl ame.

5.  Turn the control knob counterclockwise to the desired 

fl ame size. The control knobs do not have to be set at 

a particular setting. Use the knob indicator settings to 

adjust the fl ame as needed. DO NOT cook with the 

surface control knob in the LITE position. (The electronic 

ignitor will continue to spark if the knob is left in the 

LITE position.)