Frigidaire 318205854 ユーザーズマニュアル



note

The keep warm drawer is inoperable during the self-

clean cycle.
The keep warm drawer is equipped with a latch which

may require extra force when opening and closing the

drawer.

setting keeP Warm draWer control

Keep warm drawer rack positions

The rack can be used in 2 ways:
• In the upright position (Figure 1) to allow low

profile food items to be placed both under and on top

of the rack (for example, rolls or biscuits on top of

the rack and a casserole dish underneath).

• In the downward position (Figure 2) to allow you

to place light weight food items and empty dishware

(for example, rolls or pastries and dinner plates) on

the rack.

Set the keep warm drawer rack in either position.

Figure 1

Figure 2

Operating the keep warm drawer

The purpose of the keep warm drawer is to keep hot

cooked foods at serving temperature. Always start with

hot food. It is not recommended to heat cold food in

the keep warm drawer. All food placed in the keep warm

drawer should be covered with a lid or aluminum foil to

maintain quality. Do not use plastic wrap to cover food.

Plastic may melt onto the drawer and be very difficult to

clean. Use only utensils and cookware recommended for

oven use in the keep warm drawer.

Keep warm drawer recommended food settings table

Food item

setting

Bacon, Hamburger Patties

Poultry, Pork Chops

Fried Foods, Pizza

Gravies, Casseroles

MED

Vegetables, Eggs

MED

Roasts (Beef, Pork, Lamb)

MED

Biscuits, Pastries

MED

Rolls, hard

MED

Rolls (soft)

Empty Dinner Plates

Figure 3

Figure 4

Figure 5

Figure 6

Keep warm drawer temperature selection

Recommended keep warm drawer settings table is shown

below. If a particular food is not listed, start with the

MED setting. If more crispness is desired, remove the lid

or aluminum foil from the food. Most foods can be kept

at serving temperatures on the MED setting. When a

combination of foods are to be kept warm (for instance,

meat with 2 vegetables and rolls), use the HI setting. To

avoid heat loss, do not open the keep warm drawer while

in use.

note: For best results, preheat the keep warm drawer

before adding the food. An empty drawer will preheat

in approximately 15 minutes.

4. When the food is ready for removal,

touch the on●off pad once to turn

the keep warm drawer OFF. The

keep warm drawer indicator light

will turn OFF.

caution

Always use potholders or oven mitts when removing

food from the keep warm drawer as cookware and

plates will be hot and you can be burned.

To set the keep warm drawer controls

The control and indicator lights for the keep warm

drawer features are located on the control panel. The

temperatures are approximate, and are designated by HI

(high), MED (medium) and LO (low).

1. Touch the on●off pad (see Figure 6) at the keep

warm drawer control position. The keep Warm drawer

indicator light will flash. Note: If no further pads are

touched within 25 seconds the request to power the

keep warm drawer ON will clear.

2. Set the desired power level. Touch once to turn ON

the power level for HI (see Figure 3) or to turn ON

the power level for LO (see Figure 5). The keep warm

drawer indicator light located beside the on●off pad

will turn ON steady.

3. Each touch of the or pads will decrease or

increase through 5 power levels from HI (see Figure

3) to MED (see Figure 4) to LO (see Figure 5).