Smeg SE65CX ユーザーズマニュアル
Instructions for the installer
18
9.4 POSITIONING OF THE HOB
The following operation requires building and/or carpentry work so must be carried out by a competent
tradesman.
Installation can be carried out on various materials such as masonry, metal, solid wood or plastic
tradesman.
Installation can be carried out on various materials such as masonry, metal, solid wood or plastic
laminated wood as long as they are heat resistant (T 90°C).
Create an opening with the dimensions shown in the figure in
the top surface of the counter, keeping a minimum distance of
50 mm from the rear border.
This appliance can be mounted against walls higher than the
work surface on condition that a certain distance “X” be kept
between the appliance and the wall as shown in the figure so
as to avoid damage from overheating.
Make sure there is a minimum of 750 mm between the hob and
any shelf that may be installed directly above them.
the top surface of the counter, keeping a minimum distance of
50 mm from the rear border.
This appliance can be mounted against walls higher than the
work surface on condition that a certain distance “X” be kept
between the appliance and the wall as shown in the figure so
as to avoid damage from overheating.
Make sure there is a minimum of 750 mm between the hob and
any shelf that may be installed directly above them.
9.5 Mounting
Before mounting the device to the unit, lay the provided adhesive sponge onto
the glass surface to separate it from the unit.
After fixing the provided adhesive sponge (B) to the glass, mount the device to
the unit with the mounting brackets (A) provided with the device itself, as
shown in the figure.
the glass surface to separate it from the unit.
After fixing the provided adhesive sponge (B) to the glass, mount the device to
the unit with the mounting brackets (A) provided with the device itself, as
shown in the figure.