Smeg C6GGXU ユーザーズマニュアル
Instructions for the user
24
9. SPECIAL MAINTENANCE
The oven may require special maintenance or replacement of parts subject to wear such as gaskets,
bulbs, etc. The following instructions describe how to perform these minor maintenance operations.
bulbs, etc. The following instructions describe how to perform these minor maintenance operations.
WARNING
ELECTRICAL SHOCK HAZARD
Before servicing, disconnect the appliance from the power supply.
9.1 Replacing the oven light bulb
Remove cover A by twisting counterclockwise,
replace bulb B with a similar bulb. Replace the cover A.
replace bulb B with a similar bulb. Replace the cover A.
NOTE: Use only oven bulbs (T 600°F).
9.2 Removing the oven door
Open the door completely and insert the pins (supplied)
into the slots from the inside.
Close the door to an angle of about 45° and lift the door
to remove it. To replace, fit the hinges into the slots, then
lower the door until it comes to rest and extract the pins.
If the pins are lost, two screwdrivers can also be used.
into the slots from the inside.
Close the door to an angle of about 45° and lift the door
to remove it. To replace, fit the hinges into the slots, then
lower the door until it comes to rest and extract the pins.
If the pins are lost, two screwdrivers can also be used.
9.3 Removing the oven door gasket
To thoroughly clean the oven, the oven door gasket may be removed. Before removing the
gasket, remove the oven door as described above. Lift the tabs at the corners as shown in
the figure.
gasket, remove the oven door as described above. Lift the tabs at the corners as shown in
the figure.
9.4 Lubricating the surface burner gas valves
Over time, the surface burner gas valves may become stiff or jam. Clean them internally and
relubricate. This operation must be carried out by a qualified technician.
relubricate. This operation must be carried out by a qualified technician.