Smeg CS150SA ユーザーズマニュアル
23
Instructions for the User
6. USING THE HOB
Before lighting the hob burners check that the flame diffuser rings are
correctly in place with their respective burner caps, making sure that the
holes
correctly in place with their respective burner caps, making sure that the
holes
A in the flame diffusers are aligned with the plugs and
thermocouples.
For the dual burner UR2, place the burner caps
For the dual burner UR2, place the burner caps
G and F on the burner D,
ensuring that they fit snugly. The burner must then be placed on and fitted
into the base
into the base
B (taking care to use the pin C as reference). The pan stand
B supplied is for use with woks.
The special pan stand
The special pan stand
H is for use with woks.
The burner it controls is shown next to each knob. The appliance is equipped
with an electronic ignition device. Simply press the knob and turn it anti-
with an electronic ignition device. Simply press the knob and turn it anti-
clockwise to the maximum flame symbol
, until the burner lights. Keep
the knob pressed down for about 2 seconds to allow the thermocouple to heat
up. The burner may go out when the knob is released: this means that the
thermocouple has not warmed up enough. Repeat the operation, keeping the
knob pressed down for longer.
up. The burner may go out when the knob is released: this means that the
thermocouple has not warmed up enough. Repeat the operation, keeping the
knob pressed down for longer.
In case of difficulty in igniting the outer ring, when the UR-DUAL burner is
hot, light first the inner burner and then the outer one.
hot, light first the inner burner and then the outer one.
If the burners should go out accidentally a safety device will be tripped
about 20 seconds later, cutting off the gas supply even if the gas tap is
open.
about 20 seconds later, cutting off the gas supply even if the gas tap is
open.