Samson D2500 ユーザーズマニュアル

15

In order to help you protect your speaker system, the 
D2500 employs a digital Limiter. The D2500's Limiter is a 
brick wall type with a very fast attack time and a very slow 
release time.  When engaged, the digital Limiter will pre-
vent signals from reaching outputs levels over a desired 
point.  The D2500’s Limiter has a variable Threshold level, 
which is the point the limiter circuit begins to attenuate 
the system. The Limiter also has a variable Release time, 
which is the time the limiter circuit takes to return the sig-
nal to the original level.

1   

Lim. Thr. 

Threshold 

0 to -100 dB

2   

Lim. Rel. 

Release Time 

50 to 100 %

To operate the D2500 digital LIMITER follow these simple 
steps.

•  Press the LIMITER switch so that the yellow LED is lit.

•   Now, engage the effect by pressing the IN / OUT switch 

until the yellow LED lights.

•    To access the Threshold parameter, press the LIMITER 

switch until you see the menu, Lim. Th.  The LIMITER 
Threshold can be set from –100 dB to 0 dB. 

•    To access the Release parameter, press the LIMITER 

switch until you see the menu, Lim. Rel.  The LIMITER 
Release time can be set from 50 to 100 %, which is the 
equivalent to 2 to 15 seconds.

�����

������

��

The A/B switch lets you compare the actual, modified 
program to the last program recalled or stored in memory. 
After you load a preset you may want to make some 
changes to the equalization curve or perhaps to one or 
more of the digital effects. Once you make some changes 
you may want to compare the edit with the original pre-
set saved in memory. You can compare the current set 
with the preset that is stored in memory by using the A/B 
switch.  Try the A/B function to compare and preset to an 
edit by following these steps:

•   Press the LOAD switch and select any preset, then press 

LOAD again to recall the preset into memory.

•  Play some music through the D2500.

•   Now change the position of the faders so you can hear 

the equalization curve change.

•   At this point you will notice that the green LED on the 

A/B switch is lit, indicating that there has been a change 
to the original preset.

•   Now, press the A/B switch again and the green LED will 

flash indicating that the D2500 has now returned all the 
EQ faders and effects parameters back to the positions 
that were saved in the presets. You can continue to press 
the A/B switch to toggle back and forth between the 
saved preset and the new sound.  

If you like the new edited preset you can use the STORE 
function to save the new preset either under the current 
memory location or a new one.