Samson D2500 ユーザーズマニュアル

4.   The D2500 can be used either as an “in-line” device, 

as an insert device (in conjunction with mixer insert 
points), or in an effects send-return loop.  The illus-
trations on pages 20 - 22 show each of these typical 
configurations.  Choose the configuration that is 
best for your application and then begin by making 
the D2500 input connections, using the XLR con-
nectors on the rear panel.

5.   Next, make the D2500 output connections to your 

power amp or active speakers, using the XLR con-
nectors on the rear panel.  

6.   Plug in the supplied AC cord and connect it to any 

standard AC socket.  

6

SETTING UP THE D2500 to work in MANUAL mode
The D2500 is simple to use. In fact, you can use it just 
like a standard analog graphic equalizer by simply set-
ting the unit to MANUAL mode. Setting up your D2500 
Graphic Equalizer to run in MANUAL mode is a simple 
procedure which takes only a few minutes:

1.   Remove all packing materials (save them in case of 

need for future service) and decide where the unit is 
to be physically placed—it can be used free-stand-
ing or mounted in a standard 19" rack.

2.   Make sure the power to all mixers and amplifiers in 

your audio system is off.  On the rear panel of the 
D2500, place the Power switch to it’s OFF position 
and set the Main Level slider, located on the front 
panel, to it’s bottom-most “OFF” setting. 

3.  Set all Equalizer sliders to their flat (“0”) center 

detented position.