Applied Energy Products C800 ユーザーズマニュアル
Removing and Replacing Parts
31
2
Remove the four 4-mm screws located across the top of the bezel.
3
Use a scribe at the indentations to pry out the two plastic screw covers
located at the bottom of the bezel.
4
Remove the two 4-mm screws located at the bottom of the bezel.
5
Separate the bezel from the display-assembly top cover.
The bezel is secured to the display assembly top cover with plastic tabs
The bezel is secured to the display assembly top cover with plastic tabs
around the sides. Use a plastic scribe to help separate the bezel from
the top cover.
Removing the Display Panel
1
Remove the
2
Detach the
from the strain relief and the graphics
card.
3
4
Remove the 4-mm screw securing the plastic flex cable mounting
bracket to the top cover assembly.
5
Remove the six 3-mm screws (three on each side) from the right and
left sides of the panel.
6
Lift the display panel and flex cable out of the top cover assembly.
7
Disconnect the flex cable from the two connectors (a ZIF and a
standard connector) on the display panel assembly.
64mcwc11.book Page 31 Tuesday, April 3, 2001 9:58 AM