Mitsubishi Electronics E60 ユーザーズマニュアル

II - 3 

 

The number of digits in the decimal section of the parameters related to length is determined by the input setting 
unit. 
The input setting unit is set with parameter "#1003 iunit". 

B 

3 

0 to 999.999 (mm) 

C 

4 

0 to 99.9999 (mm) 

 

 

<WRK COUNT> (No. of workpieces machined) 

8001  WRK COUNT M 

Set the M code that counts the No. of workpiece 
repeated machining. 
The No. will not be counted when set to 0. 

0 to 99 

8002  WRK COUNT 

The current machining No. is displayed. Set the 
initial value. 

0 to 999999 

8003  WRK LIMIT 

Set the maximum No. of workpieces machined. 
A signal is output to PLC when the No. of machining 
times is counted to this limit. 

0 to 999999 

 
<AUTO TLM> (Automatic tool length measurement)  

8004  SPEED 

Set the feedrate during automatic tool length 
measurement. 

1 to 60000 (mm/min) 

8005  ZONE r 

Set the distance between the measurement position 
and deceleration start point. 

0 to 99999.999 (mm) 

8006  ZONE d 

Set the tolerable zone of the measurement position.
If the sensor signal turns ON in front of d before the 
measurement position‚ or if the signal does not turn 
ON after d is passed‚ an alarm will occur. 

0 to 99999.999 (mm) 

 
<AUTO CORNER OVR> (Automatic corner override)  

8007  OVERRIDE 

Set the override value for automatic corner override. 0 to 100 (%) 

8008  MAX ANGLE 

Set the max. corner opening angle where 
deceleration should start automatically.  
If the angle is larger than this value‚ deceleration will 
not start. 

0 to 180 (°) 

8009  DSC. ZONE 

Set the position where deceleration starts at the 
corner. 
Designate at which length point before the corner 
deceleration should start. 

0 to 99999.999 (mm)