Mitsubishi Electronics 838 SERIES ユーザーズマニュアル

Most setups require either a digital audio cable or 
analog stereo audio cables.  To send audio from TV 
channels received on the 

ANT input or devices con-

nected directly to the TV, you must use one of the con-
nections shown below.

The TV makes all audio available in digital and analog 

formats:

Analog audio coming into the TV is available as 

•

output in digital stereo format on the 

AUDIO OUTPUT jack.

Digital incoming audio is available as analog output 

•

on the

 AUDIO OUTPUT L and R jacks.

On rare occasions, an HDMI signal may be 

•

copy-restricted and cannot be output from 
the TV as a digital signal.  To hear these copy-
protected signals through the A/V receiver, use 
the connection for an analog A/V receiver.
Check the A/V receiver’s Owner’s Guide for 

•

information concerning use of the digital input 
and switching between digital sound and 
analog stereo sound from the TV.

Required:  One HDMI-to-HDMI cable

This option allows you to view content from devices 
connected to an A/V receiver.  The A/V receiver can 
send audio and video to the TV over a single HDMI 
cable.  You can use an HDMI connection as described 
here in addition to an audio connection from the TV’s 
audio output.  The optional audio connection allows you 
to hear, through the A/V receiver, devices connected to 
the TV only, e.g., an antenna on the 

ANT input.

838 Series:  This setup allows you to use Net-
Command-controlled audio and video switching 
over the HDMI cable.  See the full owner’s guide at 
www.mitsubishi-tv.com for details.

Y/ VIDEO