Mitsubishi Electronics C64 ユーザーズマニュアル
2. Machining Parameters
2.2 Process Parameters
4
2.2 Process Parameters
<WRK COUNT> (No. of workpieces machined)
#
Item
Contents
Setting range (unit)
8001 WRK COUNT M
Set the M code that counts the No. of workpiece
repeated machining.
The No. will not be counted when set to 0.
repeated machining.
The No. will not be counted when set to 0.
0 to 99
8002 WRK COUNT
The current machining No. is displayed. Set the
initial value.
initial value.
0 to 999999
8003 WRK LIMIT
Set the maximum No. of workpieces machined.
A signal is output to PLC when the No. of machining
times is counted to this limit.
A signal is output to PLC when the No. of machining
times is counted to this limit.
0 to 999999
<AUTO TLM> (Automatic tool length measurement)
#
Item
Contents
Setting range (unit)
8004 SPEED
Set the feedrate during automatic tool length
measurement.
measurement.
1 to 1000000
(mm/min)
(mm/min)
8005 ZONE r
Set the distance between the measurement position
and deceleration start point.
and deceleration start point.
0 to 99999.999 (mm)
8006 ZONE d
Set the tolerable zone of the measurement position.
If the sensor signal turns on in front of d before the
measurement position‚ or if the signal does not turn
on after d is passed‚ an alarm will occur.
If the sensor signal turns on in front of d before the
measurement position‚ or if the signal does not turn
on after d is passed‚ an alarm will occur.
0 to 99999.999 (mm)
<AUTO CORNER OVR> (Automatic corner override)
#
Item
Contents
Setting range (unit)
8007 OVERRIDE
Set the override value for automatic corner override. 0 to 100 (%)
8008 MAX ANGLE
Set the max. corner opening angle where deceler-
ation should start automatically.
If the angle is larger than this value‚ deceleration will
not start.
ation should start automatically.
If the angle is larger than this value‚ deceleration will
not start.
0 to 180 (degrees)
8009 DSC. ZONE
Set the position where deceleration starts at the
corner.
Designate at which length point before the corner
deceleration should start.
corner.
Designate at which length point before the corner
deceleration should start.
0 to 99999.999 (mm)
<T-TIP OFFSET> (Wear data input)
#
Item
Contents
Setting range (unit)
8010 ABS. MAX.
(For L system only)
Set the max. value when inputting the tool wear
compensation amount.
A value exceeding this setting value cannot be set.
compensation amount.
A value exceeding this setting value cannot be set.
0 to 99.999 (mm)
8011 INC. MAX.
(For L system only)
Set the max. value for when inputting the tool wear
offset amount in the addition mode.
offset amount in the addition mode.
0 to 99.999 (mm)