Mitsubishi Electronics F94GOT ユーザーズマニュアル

ページ / 44
F940GOT Handy Series
Maintenance and Diagnostics 5
5-3
5.2.2
When an operation switch or emergency stop switch does not operate
When an operation switch or emergency stop switch does not operate, check the following
points.
Check whether external cables are connected correctly to the Handy GOT. (Refer to chapter
3)
While pressing and holding an operation switch or emergency stop switch, check the
conduction between the wires (pins or terminal blocks) of the external cables and relay
cable in the table below. 
If no conduction is confirmed, wire breakage or poor contact may be present in the external
cable or relay cable, or the circuits inside the Handy GOT may be damaged. 
If it is suspected that the circuits inside the Handy GOT are damaged, consult with a
Mitsubishi Electric distributor.
*1 Connect an external cable to the Handy GOT, press and hold each switch, then check
the conduction between the pins or wires.
F9GT-HCAB-
†M
37-pin D-sub, male connector
*2 Connect an external cable and relay cable to the Handy GOT, press and hold each
switch, then check the conduction between wires.
*3 Arrangement of color type.
Switch
name
Signals whose conductivity can be checked
Signal
name
External cable
*1
External cable F9GT-HCAB-…M
+
Relay cable
*2
F9GT-HCAB2-150
F9GT-HCAB3-150
F9GT-HCAB5-150
F9GT-HCAB-3M
F9GT-HCAB-10M
SW1
SW-COM and SW1
12 and 13
White/Red and Gray/Blue (B)
*3
SW2
SW-COM and SW2
12 and 14
White/Red and Gray/Red (B)
*3
SW3
SW-COM and SW3
12 and 15
White/Red and Orange/Blue (B)
*3
SW3
SW-COM and SW4
12 and 16
White/Red and Orange/Red (B)
*3
ES1-1 ES1-1 and ES1-1
20 and 21
Pink/Red and Pink/Blue (D)
*3
ES1-2 ES1-2 and ES1-2
22 and 23
Orange/Red and Orange/Blue (D)
*3
KSW-1 KSW-COM and KSW-1
28 and 29
White/Blue and Yellow/Red (B)
*3
KSW-2 KSW-COM and KSW-2
28 and 30
White/Blue and Yellow/Blue (B)
*3
1
19
20
37
{/{
{/{
{/{
{/{
{/{
Arrangement of color (Color type)
Type A
Type B
Type C
Type D
Type E