Philips DVD Home Theater System HTS3548 ユーザーズマニュアル

48

WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Never open the system as there is a risk of electric shock.

If a fault occurs, fi rst check the points listed below before taking the system for repair. 
If you are unable to solve a problem by following these instructions, consult your dealer or
Philips for help.

–  Press STANDBY-ON on the unit to turn on the 

power.

–  Make sure the mains cord is properly connected and 

the AC outlet has power.

–  Refer to your TVs manual for correct Video In 

channel  selection. Change the TV channel until you 
see the DVD screen.

–  Press DISC/USB to select disc mode.
–  If this happens when you turn on the progressive scan 

feature, wait for 15 seconds for the auto recovery or 
switch back to the default mode as below:

  1)  Press OPEN/CLOSE

ç.

  2)  Press   on the remote control.
  3)  Press AUDIO on the remote control. 

–  Check the video connection.
–  Sometimes a small amount of picture distortion may  

 appear. This is not a malfunction.

–  The disc is dirty. Clean the disc.

–  Adjust the volume.
–  Check the speaker connections and settings.
–  Make sure that the audio cables are connected and 

press SOURCE to select the correct input source (for 
example, TV or AUX/DI) to choose the device that 
you want to hear through this unit.

–  Press SURROUND to select a correct surround 

sound setting.

–  Make sure that the source you are playing is recorded 

or broadcast in surround sound (DTS, Dolby Digital, 
etc).

–  Select the source you want to play (for example, 

DISC/USB or RADIO) before pressing the function 
button ( , í / ë).

–  Reduce the distance between the remote control and 

this unit.

–  Batteries are weak, replace the batteries.
–  Point the remote control directly toward the IR sensor.