Fujitsu S1500 ユーザーガイド
7
6.
Check the [ScanSnap Manager] icon.
⇒
The [ScanSnap Manager] icon should be dis-
played in the taskbar.
played in the taskbar.
⇒
The [ScanSnap Manager] icon should be dis-
played in the Dock.
played in the Dock.
⇒
Connecting the ScanSnap to your computer is
complete. Proceed to
"
Document Scan Test
"
.
Document Scan Test
After installing the software and connecting the Scan-
Snap and computer, use ScanSnap Manager and check
that documents can be scanned.
The following describes the document scan test proce-
dure.
Snap and computer, use ScanSnap Manager and check
that documents can be scanned.
The following describes the document scan test proce-
dure.
1.
Load the test documents into the
ScanSnap.
ScanSnap.
1. Pull the stacker on the ADF top section
towards you.
2. Prepare to load the document as follows.
3. Load the test documents on the ADF paper
chute (cover), and adjust the side guides to
the size of the documents.
the size of the documents.
It will take a few moments until the
ScanSnap is ready to be used, and the
[ScanSnap Manager] icon changes to
ScanSnap is ready to be used, and the
[ScanSnap Manager] icon changes to
on the taskbar.
It will take a few moments until the
ScanSnap is ready to be used, and the
[ScanSnap Manager] icon changes to
ScanSnap is ready to be used, and the
[ScanSnap Manager] icon changes to
in the Dock.
This describes the Quick Menu scanning
method. For other scanning methods, refer to
the Operator’s Guide.
method. For other scanning methods, refer to
the Operator’s Guide.
Stacker
Raise the
stacker
stacker
Pull out the extension
Open the side
guides
guides
Set the documents
face-down and top-first
face-down and top-first