Marantz bd8002 ユーザーガイド

35

This unit allows you to enjoy multi-channel surround sound such as 7.1-channel / 5.1-channel 
surround.
<Example of basic layout with 7.1ch surround system>

To make the most of its feature, set up your speakers appropriately by referring to the table below.
Speaker setting options are available at the following locations;
<Speaker setting for the audio signal output from the HDMI OUT jack >
(Available when you have HDMI cable connected to the HDMI OUT jack)
Setup 

A Quick A HDMI Audio Out A HDMI Multi(LPCM)

A Custom A Audio A HDMI Audio Out A HDMI Multi(LPCM)

<Speaker setting for the audio signal output from the 7.1ch AUDIO OUT jacks >
Setup 

A Quick A 7.1ch Audio Out A Multi Channel

A Custom A Audio A 7.1ch Audio Out A Multi Channel

How to navigate through the “HDMI Multi(LPCM)” and “Multi Channel” setting
1) Use [U / V] to select the menu item.
2) Use [U / V] to select setting items. 

• Use [RETURN] to go back to the previous screen.

3) Use [Y / Z] to select desired options.(Except for “Test Tone” and “Default”.)

Use [Y / Z] to select “Manual” or “Auto”, then press [ENTER].

• The test tone will be output. If you select “Manual”, use [U / V] to select desired speaker, then use 

[Y / Z] to adjust the volume. If you select “Auto”, use [Y / Z] to adjust the volume of the speaker 
that output the test tone.

• If you want to stop the test tone, press [RETURN].

Press [ENTER] to reset the “Delay Time” setting to the default.

4) Press [SETUP] to exit.

• For “Speaker Configuration”, the settings of each speaker sizes may be adjusted automatically 

corresponding to each setting. (e.g. If the “Front” is set to “Small”, the “Subwoofer” will automatically 
set to “On” and also you cannot set “Center”, “Surround”, and “Surround Back”, to “Large”.)

• If you connect to 5.1-channel surround system, set “Surround Back” in “Speaker Configuration” to 

“None”.

• “None” for “Center”, “Surround” and “Surround Back” is not available for the speaker setting for the 

audio signal output from the HDMI OUT jack .

• “Off” for “Subwoofer” is not available for the speaker setting for the audio signal output from the 

HDMI OUT jack.

Front speaker (left)

Front speaker (right)

Centre speaker

Subwoofer

Surround speaker (left)

Surround back speaker (left)

Surround speaker (right)

Surround back speaker (right)

Speaker Configuration
Select the desired 
speaker to set. Then 
change the setting 
appropriately by 
referring to the 
descriptions.

Large:
For the large speakers 
with strong low frequency 
reproduction capabilities.
Small:
For the small speakers 
which do not provide 
strong bass sound.
None:
No speakers.
For “Subwoofer” there is 
only “On” or “Off”.

Crossover Freq:
For speakers set to 
“Small”, the sound 
with frequencies 
below that of this 
frequency are cut. 
This bass sound that 
has been cut is 
output from the 
subwoofer or a 
speaker for which 
“Large” is set.

40/60/80*/
100/120Hz

Select according to the 
low frequency 
reproduction capabilities 
of the connected speaker.

E5J30ED_EN.book  Page 35  Wednesday, October 15, 2008  9:32 PM