Hunter 30756 ユーザーガイド

41558-01

Air Purifier Maintenance

Fig. 11

PRE-FILTER

HOOK

TAPE

HOOK

TAPE

6. Place the front grill back onto the unit. First, line up the tab on the bottom of

the grill with the recess on the purifier base and then push the top of the grill

forward until it is closed. Refer to Figs. 6 and 7 (pg. 7). NOTE: This unit will not

operate unless the grill is in the correct position.

7. Plug in the air purifier.

8. Finally, reset the Pre-Filter Counter by pressing the PRE-FILTER RESET key for 2

seconds. The Pre-Filter Counter will return to 100% and the Pre-Filter indicator

will stop flashing.

Cleaning the Filter

The PermaLife™ Filtration System uses a cleanable filter that never has to be changed, only

cleaned. When the filter exceeds 2800 hours (approximately 4 to 6 months of use), the Filter

Life Counter will display 0% life remaining and the Filter indicator will flash (refer to Filter

Life Counters for additional information, pg. 9). This is a reminder that you should check

the filter and clean if necessary. The proper time to clean the filter depends on usage and

the environment. Use the following list to help determine if the filter should be cleaned:

• Compare the color of the filter to the color coded chart on the inside of the housing. If

the filter color matches the darkest color on the chart, you should clean the filter.

• If you notice a decrease in air output or an increase in noise at any time during normal

operation, the filter may be clogged. Clean the filter to return to normal operation.

To clean the filter and reset the Filter Life Counter:

1. First, turn off and unplug the air purifier.

2. Next, remove the front grill. Place your fingers under the handle on the grill

and pull forward, then up. Refer to Figs. 4 and 5 (pg. 6).